Nexus Forge Single Lasso Vibrating Cock Ring

Slide the bead, pick the buzz

A vibrating lasso cock ring in silicone: a loop you tighten by sliding a bead down its two tails, with a vibrating pod at the bottom. Six modes, one button, and the fit is whatever you set.

Best forGuys who want to set their own snugness, then add a buzz.

Friday, seven o'clock, the work laptop shoved under the couch to think about what it did. You slide the bead down until the loop sits right, turn the pod underneath, and work through all six modes like a man with nowhere to be.

• Lasso fit: slide the bead down to close the loop, back up to loosen it
• Vibrating pod built into the loop, one button for six modes
• Pod on top to share it, or underneath, behind your balls, to aim it at the perineum
• All silicone, recharged by USB

How to put on a vibrating lasso cock ring

1. Charge it first. Start soft or half-hard, with a little water-based lube on you and the loop.
2. Slide the bead up, open the loop and fit it around the base of your shaft, or behind your balls too, pod on top or underneath.
3. Slide the bead down until snug, then press the button to start and again to change modes. To take it off, switch off and slide the bead up.

Care

Wash with warm water and a toy cleaner, then recharge with the included USB cable. Use water-based lube.

SafetyTake it off after about 30 minutes, and right away if you feel numbness, coldness or pain.